AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 98)

ROM Operation Mode Switch

If the power to the server is interrupted while POST/BIOS

is being updated, the server might not restart correctly. If

this happens, perform the following procedure to recover.

1. Locate the configuration switches on the system

board. For more information, refer to the label inside

the server, or see “System Board” on page 96.

2. To set the ROM operation mode to the appropriate

value, set switch 5 as shown in the following

illustration. It might be helpful to use the end of a

small screwdriver to set the switch.

Normal ROM Operation ROM Recovery Mode

12345678 12345678

ON ON

OFF OFF

3. Move the switch to the ON position.

4. Insert the POST/BIOS update (flash) diskette into

drive A.

5. Turn on the server.

6. After the update session completes, turn off the

server and remove the diskette from drive A.

7. Move the switch back to the OFF position.

8. Reinstall the cover and reconnect any cables that you

disconnected.

9. Turn on the server to restart the operating system.

10. After changing configuration switch settings, you must

reconfigure the server. After reassembling the server

(see “Completing the Installation” on page 56), use

the Configuration/Setup Utility program to reconfigure

the server. For more information, see

“Configuration/Setup Utility Program Menus” on

page 19.

90 IBM Netfinity Servers HMM

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 151 152

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 98