AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 83)

13. If you want to install or remove any other options, do

so now. Otherwise, go to “Completing the

Installation” on page 56.

Installing or Removing Drives in Bays 5 and

6: Use the following procedure for installing a drive in

bays 5 and 6. If you want to remove a drive, skip steps 4

and 5.

Notes

 You can install only 3.5-inch hard disk drives in

bays 5 and 6.

 You might need to disconnect cables from drives

that are already installed in the server.

To install a drive in bays 5 and 6:

1. Read “Termination Requirements” on page 69.

2. Remove the server cover (see “Side Access Cover”

on page 94).

3. Remove the lower drive bracket, as described in step

4 on page 72.

4. Touch the static-protective package containing the

new drive to any

unpainted

metal surface; then,

remove the drive.

5. Using the instructions that come with the drive,

together with these instructions, verify that any

switches or jumpers on the drive are set correctly.

Change the settings if necessary. For information

about termination requirements, see “Termination

Requirements” on page 69.

Attention

To ensure that the drive functions properly, do

not overtighten the screws.

IBM Netfinity 3500 - Type 8644 75

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 151 152

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 83