AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 108)

“Configuration/Setup Utility Program Menus” on

page 19.

System Board Replacement: When installing a

replacement system board or re-installing the existing

system board, care must be taken to avoid bending the

metal fingers on the EMC shield. When properly seated,

the thin fingers will be in place over the USB,

mouse/keyboard, and ethernet port connectors. To install

the system board, first angle the system board downward

and under the EMC shield fingers to prevent bending or

damaging the fingers.

Attention

1. The vital product data (VPD) and latest level of

BIOS for the system you are servicing must be

installed on the new system board. To do this,

you must run the Flash Update program using

the Flash Update diskette shipped with the new

system board FRU. A down level BIOS may

cause false error and unnecessary replacement

of the system board.

2. The processor and memory modules are

separate FRUs. Remove them from the old

system board and install them on the new one.

3. Be sure the new system board jumper setting

match the old system board jumper settings.

If replacing the system board doesn't correct the problem,

do the following:

1. Reinstall the options (processor, etc) on the old

system board and reinstall it in the system.

2. Replace the processor.

100 IBM Netfinity Servers HMM

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 151 152

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 108