AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 75)

Types of Cables: The following cables are provided

with the server:

 Four-wire

power cables

connect most drives to the

power supply. At the end of these cables are plastic

connectors that attach to different drives; these

connectors vary in size. Also, certain power cables

attach to the system board.

 Flat

signal cables

for connecting IDE and diskette

drives to the system board. Signal cables are

sometimes called

ribbon cables

. The following ribbon

signal cables come with the server to connect IDE

and diskette drives:

– The IDE signal cable has three connectors. One

of these connectors is attached to the CD-ROM

drive, one is a spare, and the third attaches to

the primary IDE connector on the system board.

– One signal cable has one connector for attaching

the diskette drive to the diskette-drive connector

on the system board.

 A flat SCSI

signal cable

for connecting devices to the

SCSI adapter.

The server is equipped with an UltraSCSI controller, it has

a ribbon cable that is connected to the internal SCSI hard

disk drive. One end of this cable is connected to the

68-pin, Channel A SCSI connector on the system board.

This cable provides four connectors for attaching other

internal SCSI devices. For correct termination, see

“Termination Requirements” on page 69.

For more information about SCSI devices, see “SCSI

Drives” on page 68.

To properly install a 3.5-inch drive in bay 2, use the 3.5-inch

conversion kit for a 5.25-inch bay that is already installed in bay

2. If you are installing a 5.25-inch drive in bay 2, you must first

remove the conversion kit.

Removable media include &cd.s, optical discs, diskettes, and

tapes. However, the server only supports one diskette drive

(standard in bay 4).

In some models, the &cd. drive might be set as the default

startup (or boot) drive. However, if a hard disk drive is

preinstalled, you can change the startup sequence, and specify

the hard disk drive as the startup drive. See “Start Options” on

page 21 for information about changing the startup sequence.

Drives that are higher than 41.3 mm (1.6 in.) cannot be

installed.

One slim-high drive has a height of 25.4. mm (1.0 in.). One

half-high drive has a height of 41.3 mm (1.6 in.). Therefore,

you can install two slim-high drives or one half-high drive

between bays 5 and 6.

IBM Netfinity 3500 - Type 8644 67

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 151 152

Kommentare zu diesen Handbüchern

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 75

Kommentare zu diesen Handbüchern