AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 58)

Adapters

Note

For a complete list of the adapters that the server

supports, go to http://www.pc.ibm.com/us/compat/ on

the World Wide Web.

When you are installing or removing adapters, it is

important to resolve any resource conflicts that might arise.

For example, if you install an ISA legacy adapter, you

might need to manually configure the adapter by setting a

variety of switches on the adapter and by using the

Configuration/Setup Utility program.

Many adapters now use

Plug and Play

technology, which

enables the server to automatically configure the adapter,

provided that the required resources are available. Refer

to the instructions that come with the adapter to determine

if it is Plug and Play. For more information, see “ISA

Legacy Resources” on page 27.

Considerations: The server supports ISA and PCI

adapters. You can install up to six adapters in the

connectors on the system board. These connectors are

known as

expansion slot

connectors.. The expansion slots

are located on the rear of the server (see “Input/Output

Connectors” on page 78 for an illustration).

The server system board contains two 16-bit, ISA-bus

expansion slot connectors and four 32-bit, PCI-bus

expansion slot connectors. One expansion slot connector

is a shared PCI/ISA slot connector. One slot connector

supports only ISA adapters; the remaining slot connectors

support only PCI adapters. The server supports only

5.0-volt adapters on the PCI bus.

Notes

1. Slot 1 is an Accelerated Graphics Port (AGP).

You can install only a special AGP graphics

adapter in this slot. The server comes with an

AGP graphics adapter installed in this slot.

2. You can install only a half-length PCI adapter in

expansion slot 2. You can install half-length and

full-length adapters in expansion slots 3 through

3. If you have high-performance PCI adapters, such

as RAID adapters, install them in expansion slots

3, 4, or 5. Do not use slot 2 for

high-performance PCI adapters.

4. If a component in the server or on the adapter

interferes with the installation, use another slot.

The following figure shows the location of the expansion

slot connectors on the system board.

50 IBM Netfinity Servers HMM

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 151 152

Kommentare zu diesen Handbüchern

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 58

Kommentare zu diesen Handbüchern