AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 36)

To store the legacy resource information for an

installed adapter:

1. Select ISA Legacy Resources; then, use the Up

Arrow (↑) or Down Arrow (↓) key to highlight the

system resource that you want to change.

2. Select a resource; then, use the Left Arrow (←) or

Right Arrow (→) key to select a configuration choice.

If you remove an ISA legacy adapter, you must redefine

the system resource as Available.

Power Management: With Power Management, the

server and monitor can be set to use a reduced-power

state if they are inactive for a specified length of time. You

can also specify options to automatically start the server.

Attention:

The ACPI BIOS Mode feature is the only available Power

Management feature.

The APM BIOS Mode feature is set to Disabled. Do not

change this default value.

Using the Automatic Configuration and Power

Interface BIOS Mode:

When the automatic

configuration and power interface (ACPI) BIOS mode is

enabled, the operating system controls the power

management features of the server and the settings for

APM BIOS mode are ignored. Refer to the

operating-system documentation to determine if ACPI is

supported.

To set ACPI BIOS mode:

1. Select Power Management from the

Configuration/Setup Utility program menu.

2. Set ACPI BIOS Mode to Enabled or Disabled as

desired using the Left Arrow (←) or Right Arrow (→)

key.

Configuring the Ethernet Controller

The Netfinity 3500 server comes with an Ethernet

controller on the system board. The Ethernet controller

provides 10BASE-T and 100BASE-TX support through the

RJ-45 connector on the back of the server. When you

connect the server to the network, the Ethernet controller

automatically detects the data-transfer rate (10 Mbps or

100 Mbps) on the network and then sets the controller to

operate at the appropriate rate. That is, the Ethernet

controller will adjust to the network data rate, whether the

data rate is standard Ethernet (10BASE-T), Fast Ethernet

(100BASE-TX), half duplex (HDX), or full duplex (FDX).

This process is also known as auto-negotiation. This

auto-negotiation occurs without requiring software

28 IBM Netfinity Servers HMM

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 151 152

Kommentare zu diesen Handbüchern

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 36

Kommentare zu diesen Handbüchern