AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 80)

d. Remove the screws that secure the top and the

bottom of the upper drive bracket.

e. Slide the drive bracket to the rear approximately

25 mm (1.0 in.); then, slide it sideways until it is

out of the server.

f. If the drive that you are installing has removable

media, remove the static shield from the drive

bay where you are installing the drive.

g. Continue with step 5.

4. To access bays 5 and 6:

a. Remove the screw that secures the lower drive

bracket.

b. Lower the front of the drive bracket, lift up on the

rear, and slide it out.

c. If necessary, disconnect the power and signal

cables attached to the drives in the lower drive

bracket.

d. Continue with step 5.

5. Touch the static-protective bag containing the drive to

any unpainted metal surface on the server; then,

remove the drive from the bag.

6. Check the instructions that come with the drive.

 To install a drive in bays 1 through bay 4, go to

“Installing or Removing Drives in Bays 1 through

4” on page 73.

 To install a drive in bays 5 and 6, go to

“Installing or Removing Drives in Bays 5 and 6”

on page 75.

72 IBM Netfinity Servers HMM

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 151 152

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 80