AUDIOLINE WAVE 10X Technical Information PDF herunterladen (Seite 84)

6. Install the drive into the lower drive bracket so that

the power and signal cable connectors are facing the

open side of the server. Align the screw holes and

insert two screws on each side of the drive assembly

near the bottom, as shown.

Attention

1. If the server comes with a drive installed in

bay 6, two screws are attached to each side

of the drive assembly.

If you remove a drive from bay 6 and install

another drive in that bay, use the screws

that come with the preinstalled drive.

2. If you are installing a drive in bay 5, turn the

drive upside down before you slide it into

the bay. This ensures that the drive

connector will align with and attach properly

to the cable connector.

When you install the four screws that come

with the drive, attach them to the drive from

the top.

3. If you are installing a drive in bay 6, hold the

drive with the connector side up before you

slide it into the bay.

If the server is an open-bay model, when

you install the four screws that come with

the drive, attach them to the drive from the

bottom.

76 IBM Netfinity Servers HMM

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 151 152

Keine Kommentare

AUDIOLINE WAVE 10X Technical Information Seite 84